Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Abaqus Error

Status
Not open for further replies.

FarhadAhmadi

Student
Joined
Sep 27, 2022
Messages
2
Location
US
Hi everyone,

Does anyone know how to retrieve the element sets identified by Abaqus when no ODB file is made by the software? I am trying to perform an analysis, but it gets aborted before the software creates a result file. Therefore, I cannot create a display group to see the identified problematic elements.

#Abaqus
#WarnNodeAdjust
#WarnNodeMissMasterIntersect
#ErrElemVolSmallNegZero

1_iyh6yw.png
2._cdxpz1.png


Capture_jhx0sv.png
 
Try running datacheck analysis. This error is often caused by too large adjustments within tie constraints.
 
Thanks FEA way for the response. I am still curious to see the exact location of the problematic elements, however, cannot find the mentioned element sets since the ODB file has not been created so that I could look into the display groups in the visualization module. Any comments on this would be highly appreciated.
 
Did you try with datacheck run ? Is the .odb file created then ? It should appear in the current work directory.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top