Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Abaqus error (only one type of region may be selected at one time)

Status
Not open for further replies.

owais ahmed

Student
Joined
Nov 10, 2021
Messages
10
Location
DE
Hallo guys,
I created this part geometry in abaquscae and then transported this file to hyperworks for meshing.After doing the transition mesh in hyperworks i exported the part to abaqus cae. But when i defeined the property and tryinf to assign the section .Abaqus is giving me this error (only one type of (cell,face or edge) may be selected at one time ). I am attaching the screenshot of geometry and the picture of error that i am getiing .please find the attachement and give me some helpful suggestions in this regard.

part_mesh_c70nqe.png
error_y9srtb.png
 
It's likely that the mesh exported from Hyperworks includes some redundant element types - likely shell and maybe also 1D. Check the types of elements in the input file and remove those that are not needed.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top