Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

A193 B16 Stud Bolts size 1" produced from 23.23mm size rod

Status
Not open for further replies.
ZAbbas101054

ZAbbas101054

Materials
Joined
May 18, 2014
Messages
6
Location
SA
Sir,

Could some one explain how the stud bolt size 1" be produced from 23.23mm size round bar i.e slightly greater size be produced from smaller size material.

Thanking in advance.
 
Sort by date Sort by votes
Rolled threads?

Regards,

Mike
 
Upvote 0 Downvote
The thread rolling process uses a blank at pitch diameter to make the final part with the thread major diameter larger and the minor diameter smaller than the original blank diameter.
 
Upvote 0 Downvote
Experts,

Thanking you all on your precious replies.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

C
  • Locked
  • Question Question
ASME B16.11&B16.5
Replies
3
Views
4K
SnTMan
SnTMan
G
  • Locked
When I looked at the specification ASTM C33 I did not find the specification limits for the 1/2-inch sieve as mentioned in the
Replies
0
Views
1K
GHADA ALQARESH
G
qcrobert
  • Locked
  • Question Question
How can steel manufacturer chemical composition differ from ASTM/ASME chem comp?
Replies
5
Views
1K
qcrobert
qcrobert
Braham0123
  • Locked
  • Question Question
ASTM A193 B16 Mechanical Requirements - Tolerances
Replies
2
Views
298
SnTMan
SnTMan
Andrewstructure
  • Locked
  • Question Question
Cast Steel - Johnstown Works Grade SX, .10-.20 C
Replies
0
Views
717
Andrewstructure
Andrewstructure

Part and Inventory Search

Sponsor

Back
Top