Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

6418

Status
Not open for further replies.
metass

metass

Materials
Joined
Sep 11, 2006
Messages
7
Location
US
Can 6418 be austempered?
 
Sort by date Sort by votes
If you are referring to the steel grade specified in SAE AMS 6418, the answer is yes it will respond to austempering, however, the transformation time to bainite will likely be greater than 24 hours, which usually renders the process unsuitable. Highly alloyed steels, especially those with considerable amounts of nickel, are generally not used for austempering due to this phenomenon. These grades have been created specifically to stabilize the austenitic phase so that they can be quenched into martensite, and then subsequently tempered to produce high strength and high toughness.
 
Upvote 0 Downvote
From what I could find on AMS 6418 (aka as Hy-Tuff steel), and depending on size (thickness), I would say that it can be austempered. The Nickel content is in the range of 1.65 to 2%.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

LM86
  • Locked
  • Question Question
Carburizing AMS 6418
Replies
2
Views
111
redpicker
redpicker
harsuda
  • Locked
  • Question Question
Can SAE AMS 6418 be carburised?
Replies
1
Views
98
swall
swall

Part and Inventory Search

Sponsor

Back
Top