Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

3D file Import for Magnet

Status
Not open for further replies.
Kalpesh43

Kalpesh43

Mechanical
Joined
Jan 26, 2018
Messages
1
Location
GB
Hello Guys,

Can anybody suggest any resources for styding MAGNET Software from infolytica.
I have manual from them which is good enough for 2D problem but doesn't say much about 3D modelling and importing files into the MAGNET.


Regards,
Kalpesh
 
Status
Not open for further replies.

Similar threads

Coco_HueHueHue
  • Locked
  • Question Question
Permanent Magnet Synchronous Generator (PSMG) - Searching for references and standards
Replies
15
Views
5K
waross
waross
Clyde38
  • Locked
  • Question Question
DC armature winder for large diameter magnet wire
Replies
0
Views
302
Clyde38
Clyde38
SA07
  • Question Question
Alternative diode protection relay for power alternators
Replies
0
Views
5K
SA07
SA07
rumahhutan
  • Locked
  • Question Question
Formula for Rewinding Motor without Nameplate
Replies
2
Views
2K
TugboatEng
TugboatEng
RonOz
  • Question Question
Wiring diagram for a petrol generator required
Replies
18
Views
7K
BrianPetersen
BrianPetersen

Part and Inventory Search

Sponsor

Back
Top