D
D. Urban
Guest
I have upgraded to 2013 but I'm having a problem with:
Drawings are disconnecting the bom balloons if the drawing was a copy of another configuration. balloons must be re-connecter by selecting view properties and "check box link balloon text to property".
We have a lot of drawings has anybody else experienced this and is there a way to fix it without having to go through each drawing / view?
Regards:
Dale
Drawings are disconnecting the bom balloons if the drawing was a copy of another configuration. balloons must be re-connecter by selecting view properties and "check box link balloon text to property".
We have a lot of drawings has anybody else experienced this and is there a way to fix it without having to go through each drawing / view?
Regards:
Dale
