2008 Electrical Routing

[Sp1n]

In wiring summaries in 2007, it was possible to set the connectors to show a 'fan out' of wires to the corresponding pins.

2008 now has the 'Flatten Route' capability which is awesome!. However, it does not show the individual wire-to-pin geometry nor is there a 'fan out' option. Does anyone know if this is possible in '08 using 'Flatten Route'?

 

[SBaugh]

I know you have to define your pins and wires, so be sure you do that.

Regards,

Scott Baugh, CSWP

http://www.scottjbaugh.com

"If it's not broke, Don't fix it!"

faq731-376