Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

1/4" Delrin

Status
Not open for further replies.
FabproHelp

FabproHelp

Mechanical
Joined
Dec 1, 2015
Messages
64
Location
US
Does anybody have any experience cutting delrin on a laser before? we have experimented with trespa in the past but never something like this. Looking for cut condition input.

Thanks
 
Sort by date Sort by votes
Delrin burns with an almost invisible smokeless flame. It breaks down into formaldehyde which then burns cleanly. If the formaldehyde does not burn, it will be a toxic gas issue.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Garrett Green
  • Locked
  • Question Question
Mazak Laser having trouble cutting 1/2" Material
Replies
0
Views
1K
Garrett Green
Garrett Green
markovlahov
  • Locked
  • Question Question
Amada ALpha 4 LC 2415 NT - help
Replies
0
Views
500
markovlahov
markovlahov
metalbiz
  • Locked
  • Question Question
Higher wattage laser or waterjet for 1/4" aluminum?
Replies
5
Views
552
krugtech
krugtech
Co2_Marcus
  • Locked
  • Question Question
Amada 3015 FOM2 4kw laser, 8-10mm problem with small holes
Replies
0
Views
437
Co2_Marcus
Co2_Marcus
Darren Bendall
  • Locked
  • Question Question
Bystronic Bystar 3015 4.4kw
Replies
10
Views
2K
krugtech
krugtech

Part and Inventory Search

Sponsor

Back
Top