Tatoz
Mechanical
- Sep 24, 2002
- 6
This one is a tough one and I hope it can rise a good discussion.
We need to make 0.006 holes on a 0.125 Antimony Lead plate, we've achieved good results with 0.01 drills on 0.1 SS plates but we still have to try now with this smaller diameter on this not so common material.
Thanks to all takers of this challenging thread.
We need to make 0.006 holes on a 0.125 Antimony Lead plate, we've achieved good results with 0.01 drills on 0.1 SS plates but we still have to try now with this smaller diameter on this not so common material.
Thanks to all takers of this challenging thread.