Hi All,
I was hoping to get some input on this situation. Currently, anytime a net-list is run in routing electrical package for NX the B curve changes in length anywhere from a quarter of mm to a mm. I was wondering and hoping if there is away to prevent this from happening. I have to go back...
How can I check a total wire harness to all of its background at one time? I am routing wire harness, so I know there is area that is going to touch or crash. Such as, clips going through a hole location which is totally fine. However, I am looking for areas of the harness that crash into the...
When applying the overstock it tends to pop off after the harness is routed or if you try and edit a curve while the harness is routed. It only removes a portion of the overstock and not necessarily in the area that's being edited. Is there a particular preference that should be set or a...
Hello Everyone,
I am trying to export catia v5 models to NX 7.5. I believe this should be very simple. If someone can give me a simple step by step solution it would be greatly appreciated
