Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Profile Tolerance Question
Personally, I didn't know you could check a datum against itself.- zumkatze
- Post #5
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Profile Tolerance Question
The customer's drawing is pointing a profile tolerance to a datum. Is it correct to check the profile tolerance of the datum surface itself?- zumkatze
- Post #3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Profile Tolerance Question
Hello, I have a customer's drawing of a sheet metal part with a flange bent at a 91 degree angle from the top surface. On this flange surface, they indicate two Datum B points with the top surface as Datum A. Also on the flange surface, they have a GD&T profile callout of .060 to A, B, & C (a...- zumkatze
- Thread
- Replies: 5
- Forum: Drafting Standards, GD&T & Tolerance Analysis
