Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Tasa75

    Problem cutting 8mm stainless

    If you can easily remove these by punching from a side,use the same settings and put a bigger nozzle (hk30). Can you share your .PAR file for 8mm stainless steel?
  2. Tasa75

    bylaser 2200 start turbine blower problem

    Latest news from the Turbine: The inverter output frequency falls below 285 HZ for some reason.Do not see any damage on the inverter inside.Have checked all the parameters and 401 and 402 (401= limit current 1;402 = limit current 2) I have raised them up.As I was increasing them, frequency got...
  3. Tasa75

    Changing the head lense?

    Don´t have much experience with lenses, because I am working for two years with laser,but here it is : I have lens on the 7.5" head that has mark on the lower side in the middle of it and it is not mark as something is burnt on the lens,it looks like thermal damage on the lens it self.It cuts...
  4. Tasa75

    bylaser 2200 start turbine blower problem

    Dear Chris, the problem is with one of the digital signals.But on the frequency inverter, the frequency is set to 290 HZ, and the actual value is between 284HZ and 287HZ. When it is below 286HZ the signal "turbine running at the rated speed" is missing, but the thing is that then turbine does...
  5. Tasa75

    bylaser 2200 start turbine blower problem

    Yes Chris, there was an error :"phase failure" in previous errors, now there is no fault.
  6. Tasa75

    bylaser 2200 start turbine blower problem

    Thanks Chris, yesterday I have started the machine.[pipe]Today machine was running , but on the display of frequency inverter, there is a message:"overcurrent".It is working , but I am concerned about posibille damage to inverter and blower. However, today I have finished the urgent jobs, and...
  7. Tasa75

    bylaser 2200 start turbine blower problem

    Hallo everyone, can someone help me with this issue? The machine is Bystronic Byvention with Bylaser 2200 resonator .Machine is started this morning and in the afternoon there was an alarm:"the turbine blower runs outside the permitted range". In a few minutes after resetting the alarm machine...
  8. Tasa75

    Bystronic tool radius compensation issue

    hello there, i am new in laser world and in this community also. I have one issue that i want to share with you.I am runnung Bystronic Byvention 3015,and i have some problems with tool radius compensation.During the cutting process i am allowed to change tool compensation, but sometimes the...

Part and Inventory Search

Back
Top