well this can be easy does your plc have the ability to vary is voltages or just pos and neg? if it is you can use it to vary the voltage to increase or decrease the input voltage to the chuck. there are systems out there to do that all they need is an input. Now demag tho that can be tricky you...
always remember the sensitivity of the magnet differs because of size of your strings the low e is a large string and the high e is smaller therefore it creates less current there for less volume. they are all right in that you need to move them closer for each string or use slightly stronger...
Ok i have worked an many a rf gen most were lower freq 13.5mhz to 40mhz and have also worked hf right on thru micro in the military. Now the higher your power the better isolated your dc must be this is very important that rf chokes (large gauge and due to the fickleness of rf you will have to...
hi all im looking for some information on e-beams. Mostly air propagation and tuning if you can help it would be wonderfull. thanks fellas hope to hear soon.
morg
Most do need vacume because the properties of highenergy plasmas is that when those particals hit any others they cool and lose energy from the collisons that is why you need magnetic confinement to create very high temp plasmas or lots of power plasmas will degrade very fast in an atmosphere...
ok the biggest part of the vasmir is the ability to thrust as in to vary the actuall output of the engine were as many ideas on the boards now have 2 settings off and on this has the ability to increase and decrease the actuall "thrust" output of the engine and yes it is for vacume...
ok the easy way is to buy a small scale de-mag coil try it out on the area about to be welded these coils are cheap and easy to obtain they are used in the tv industry to de-mag video screens hope it helps
morg
ok first off it depends on the type there are many types of ion engines some cheap and others very expensive. If money is a factor then a cluster of simple hall effect thrusters useing say mercury or teflon (teflon being more expensive) could be used these were most made in russia and have a...
on that long of a fligh5t the bio mass would be reused due to a few reasons one carbon is lost to us easting the plants and the feces would renew that 2 the nitrogen that is also found in feces would help the soil (since you will have to grow food for that long of a trip)
morgothia
ok a vasmir engine would require a much higher power lift vehicle in the fact it has fuel and a power source since it is made for larger space vehicles the current vasmir is larger than one meter in size since the engine is made so that the trust is variable hence the name vasmir it is a plasma...
sorry took so long to reply i have been very busy. The reason why i need to know this is for a form of magnetic bearing useing ceramic magnetics (so as not to induce a current in the magnetics and cause drag) so i am trying to figure the guass needed to support the weight properly without...
demag is a rough thing for one useing non magnetic mounts, bushings, and housings will reduce the effect of the motors magnets on the frame of you equipment. degaussing on monitors for computers are done with a simple circular coil as odd as it may sound a monitor degausser might just do the...
hello all I am new to this board but i am looking for any information anyone has on converting gauss to relative force measurements for repulsion effects of ceramic magnetic meterials. I know there isnt much published on this so any information you may have stumbled apon or learned would be...
