Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. pwr165523

    Assembly center of mass - how to obtain time-dependent CM position?

    Ok, so today I have found a new source of information that is most likely appropriate in my case. There is a thread on another Adams forum entitled: " How to link a marker to determine the location of aggregate mass of an assembly" Someone responded to that with such a message: Use GCON and...
  2. pwr165523

    Assembly center of mass - how to obtain time-dependent CM position?

    Hello, I have a model of my device already built. When I am using the aggregate mass function, it only gives me the coordinates of CM for the initial machine position. My aim is to see the CM position during the whole simulation. I have made a measure, defined by such a function: AGGREGATE_MASS(...
  3. pwr165523

    parameterization problem

    Thanks for the reply, Hmmm.. To be honest I am not familiar with other ways of working with adams than just via GUI. But it is weird for me that I can't relate one marker to the other. It should be simple (like with marker-point relation). It has to be possible. Simple command: marker of this...
  4. pwr165523

    parameterization problem

    Hello, I have tried to model and parameterize a simple four joint mechanism. Of course I can manipulate with point positions by entering different values in table editor. But when it comes to parameterization of links (markers) it doesn't work like that. I have set link's lengths as design...

Part and Inventory Search

Back
Top