Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. ATriple

    ASME B31.1 & Section I material identification

    Ah...did not realize that you were asking about Section I material markings. My apologies - at least anyone interested in Section VIII Div. I requirements knows where to find them now. :)
  2. ATriple

    ASME B31.1 & Section I material identification

    UG-77(a), UG-93(a)(2), and UG-94 (just a few that I found) explicitly state that material markings required by the applicable Section II material specification must be transferred to each new piece, both for traceability and to satisfy the Inspector. If the material specification does not...
  3. ATriple

    Section VIII circumferential ligaments

    BigTank, UG-53(d), (e), and (f) allow for the calculation of circumferential efficiencies. You would calculate them the same way you calculate diagonal ligaments, using 90 degrees as your "angle with longitudinal". Depending on your specific setup you may need to use either Figure UG-53.5 or...

Part and Inventory Search

Back
Top Bottom