Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Acid plant - Inlet Quench
mqas, At two of our operations we are testing brick lined stainless steel. The stainless is first lined with a rubber lining and then brick lined. This is the most promising solution so far. The stainless is only there in case the lining fails. If it does give good service life, the next...- bphil
- Post #7
- Forum: Corrosion engineering
-
Acid plant - Inlet Quench
Hacksaw, There is some fluoride but the actual concentration is unknown. I would say that the fluoride concentration is somewhere between 0 - 500 ppm. Phil- bphil
- Post #5
- Forum: Corrosion engineering
-
Acid plant - Inlet Quench
For those of you who are familiar with the Inlet quench of smelter's sulfuric acid plant, as you may expect, we are experiencing corrosion problem on this equipment... The inlet quench is the area where hot SO2 (300 C) gas coming from Nickel or Copper smelter is quenched by weak acid spraying...- bphil
- Thread
- Replies: 8
- Forum: Corrosion engineering
-
409 stainless steel piping
The reason why I don't fabricate it out of 409 plates is that it is very difficult to roll for 8" diameter and it is also very hard to find in thick (0.5") gage. Thanx again Phil- bphil
- Post #7
- Forum: Metal and Metallurgy engineering
-
409 stainless steel piping
Thank you guys, so I conclude that I won't find it anywhere. What I'll probably do is cast it. I really don't need strong mechanical properties for this application, it is just a corrosion allowance to protect from a mixture of air-HCl-chlorine gas at 500 C. It is not welded, it is...- bphil
- Post #5
- Forum: Metal and Metallurgy engineering
-
409 stainless steel piping
Hi, I've tried to find 409 stainless steel piping for the last week. All I find is 409 tubing as per ASTM A268. But this kind of tubing is too thin for my needs. I need a 8" sch 80 409 stainless steel pipe. I'm thinking about casting it now, does anybody knows where can I find such...- bphil
- Thread
- Replies: 7
- Forum: Metal and Metallurgy engineering
