Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. ad911001

    Differences between A182 F51 and A815 WPS31803

    What an incredibly useless response
  2. ad911001

    Differences between A182 F51 and A815 WPS31803

    I realize the chemistry is the same for both products. Are there any discernible differences between these two? Our spec calls for A815 WPS31803 and our supplier says they only provide A182 F51 for products 4" and below. Why is this?
  3. ad911001

    Minimum Temperature for Hydrotesting

    If you use a non freezing test media such as a water/glycol mixture, your min test temperature should be governed by your minimum design metal temperature (MDMT) which should be listed in your LDT. This can very greatly depending on the size of pipe, type of fitting, material, schedule, etc.
  4. ad911001

    Thermal Shock of Pipe - How big of a temp differential is needed?

    Hello - We are looking at pressure testing some pipe. It will be a heated test with the fluid heated to ~80C. It will then be introduced to the system of heavy walled, #1500 carbon steel pipe that may have cold spots on exterior sections as low as -25C. I feel like the temperature differential...
  5. ad911001

    Conveying bulk material around a 36' diameter circle. Best method?

    Looking for ideas or tips on this subject. I thought maybe a tubular chain conveyor would be applicable in this case. Does anyone here have any experience with these types of conveyors? How is the reliability, preventive maintenance and standard maintenance on these? example
  6. ad911001

    Force and momentum diagram for an isosceles trapezoid

    Thank you for the reply. The thickness of the mold is three inches, everywhere. I don't see how the material is relevant, I'm just looking for the internal stress at the middle of the top lip section. This will be the same for any material. Also, disregard the temperature, assume it is room...
  7. ad911001

    Force and momentum diagram for an isosceles trapezoid

    Hello I am trying to figure out the effect of stacking molds of hot liquid material on top of other molds. I know there needs to be a moment analysis but my statics knowledge has been lost. We are seeing cracks develop in the center of the molds and I'm looking to see what is the actual...

Part and Inventory Search