SeasonLee, Thanks for the correction. This form of notation is new to me but as EWH pointed out, its the 2009 standard. I'll need to get some current drawing standards and familiarize myself with the use of circle U. I did attempt to indicate a unilateral tolerance with the offset dashed line...
After reading your comments and going through ASME Y14.5-1994 I think what I have attached is correct. The standard seems to say it would be incorrect to use MMC here unless its attached to a position control. Thanks for your comments.
Thanks all for your comments. I just purchased geometrics III and will use that in addition to the above comments to take another crack at this. I'll post it up when I think I've got it to see if you agree. Thanks again.
First post, I goofed the attachment. I hope this works...http://files.engineering.com/getfile.aspx?folder=96d84864-1191-4da1-a788-149e07a92fdd&file=EXAMPLE.JPG
I have a project involving two irregular shapes which must fit inside each other without interference. I'm trying to figure out if I have the GDT notation correct. The attached picture should explain itself. Anyone care to offer a suggestion?
Thanks!
