Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. madnut

    BTOL-Command

    The volumes are generated directly in Ansys 11. They share boundery lines and therfore also boundary surfaces, but can't be attached. Another attempt with overlapping volumes wasn't successful either. Regards, Madnut
  2. madnut

    BTOL-Command

    Hi! For creating a geometry in ANSYS CLASSIC, with which I don´t have a lot of experience, it is inevitable that I add two volumes using the boolean operation. However I´m receiving the following error message: "Boolean operation failed: Adjust the tolerance value on the BTOL command to some...

Part and Inventory Search

Back
Top Bottom