I figured it out, it was a combination of different problems. First the were a couple of points on the sketch that were not fully defined. This was keeping the angles from resolving properly. The second issue was when I opened the drawing after originially creating it opened in the "as...
SW 2009 with the latest service pack installed. I finally got the angles in the cut list by retrimming corners that had already been trimmed. Now the length in the Cut List does not match the dimensioned length in the drawing. I am still trying to get it to work so the part is quite screwed up...
I am a Solidworks newbie and I am trying to make a weldment drawing. The weldment is basically a trapezoid made out of 2 inch square tubing. I can model the weldment with no problem and I have been trying to make a drawing out of the part. The problem arises when I bring in the weldment cut...
