Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. joeskin

    Existing Timber Crib Walls

    Thanks again to both of you. I feel the same about leaving the ties in place and with proper drainage it should not create problems. Sometimes it's hard to convince code officials. MSEman - The is actually in northern New Jersey. There is approximately 5' of clearance from the existing...
  2. joeskin

    Existing Timber Crib Walls

    Both great ideas. Thanks. There is room for this, as well as the construction of a large block wall to a max height of 10'. My one concern is the deterioration of the existing ties and the creation of voids over time. From your response, I'm assuming you have experience with leaving the ties...
  3. joeskin

    Existing Timber Crib Walls

    I am working on a very complex wall design to replace an existing tiered timber crib wall system. The bottom wall has deteriorated. The upper wall looks as if it was recently replaced by the neighboring property owner. There is limited room to work. The upper wall retains a parking lot and...
  4. joeskin

    Proctor testing of 3/4" clean stone

    Does anyone have a clear idea on what standard to use for performing a proctor on 3/4" clean stone to be used in soil replacement? I've heard that the material is to be crushed, etc. Any advice will be greatly appreciated. Joe
  5. joeskin

    RCA as a Structural Fill

    Does anyone have any experience using Recycled Concrete Aggregate as a subbase for a building foundation? Have a situation where the proposed building is to be constructed in an area that contains peat. The contract calls for removal of all peat and replacement in controlled compacted lifts...
  6. joeskin

    14 Gauge steel tolerences

    I'm looking for the inherent minimum bend tolerence for 14 G steel. Is there a good book/soure where this can be found? Cheers! Joe
  7. joeskin

    Boulder Retaining Wall Design

    Need some assistance with a boulder wall design. Is there a good book or program to use to speed up the process? any and all help will be appreciated. Joe
  8. joeskin

    Auger cast in situ piles

    I have a project that requires piles to be installed inside a warehouse. Timber can work, but there is a height restriction. Can Auger cast be used? Can they be 12" diameter? Thanks. Joe
  9. joeskin

    field testing to determine internal angle of friction

    I have a WONDERFUL retaining wall project that I need to determine both the bearing capacity and internal angle of friction for the native soil as well as the infill material. The infill is recycled concrete (RCA). Access to the site is limited so I can't use a drill rig of any size. Need to...

Part and Inventory Search

Back
Top