Hi,
I would like to post a doc from Moldflow HELP.
The Weld lines result is generated at the end of a filling analysis. This analysis shows where weld lines are likely to occur on your model along with the angle at which the flow fronts converge to form the weld line. Weld lines occur where...
Hi,
For cooling package, Moldflow recommended to use cool + Flow + Warp analysis procedure because mold temperature distribution is very important for Warpage prediction.
I am not sure a analysis result oof warp without cooling analysis.
you do not need if you sure your mold temperature...
If you use uniform thickness model, I would like to use a midplane mesh than the others.
The midplane ceneration is not easy matter with complex geometry, therefore you have to consider hot to make a midplane model.
Moldflow has been introduce the Caddotor software to clean a model geometry as...
