I am replying from my phone so can't post prints. It is for a 25mm needle bearing the dimensions used for the OD are the ones in the bearing manufacturers shaft specs.
I would really like to avoid grinding if possible after heat treating. D2 sounds good but like someone said price will be a issue, could A2 be an alternative?
Thank you very much for the input guys.
This will be a shaft for a needle bearing clutch that needs to be heat treated to 58C. OD .986" by .800" long with M14 thread. Tolerances are .001+- on the OD. This will be a high volume piece.
The plan right now is start with 1” E52100 and machine on the CNC to correct dimensions then heat...
Tops one minute. These are cores so we do not have any info on the parts coming in. We currently have guys id the parts by tribal knowledge that have years of experience. Even then they can take up to a couple of minutes on the parts they cannot id, they process about 2000 parts each for a total...
I just started a new project and need some advise-Ideas. I work for an automotive parts remanufacture. The project I am working on consists of a system that will identify each part-core that comes in by part #. We have over 1600 part #s. I am currently working on a trial-Demo vision system that...
