Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Where can I find a laser cutting service?
Quote "Yes there are lots. But the ones I've phone do >0.5mm or it is a sideline to something else, or they don't do steel, or they prefer large customers/orders, or they are ""very expensive."" " I have the only laser around my parts and I get a lot of inquires for odd parts with very low...- Mario428
- Post #10
- Forum: Laser engineering
-
NITROGEN GENERATORS
We switched after 3 years of using liquid nitrogen. Would never go back. In nitrogen's defence the liquid was a better cut but we are somehwat remote and I had to plan a week ahead for my neeeds. The scheduling of making sure I had enough nitrogen without wasting it was a nightmare. We got the...- Mario428
- Post #9
- Forum: Laser engineering
-
More LC1212 questions
Tech guy from my dealer finally got back to me and told me the same thing as msadoval and the corners are cutting great now. Thanks- Mario428
- Post #4
- Forum: Laser engineering
-
More LC1212 questions
We are now cutting mild steel hot rolled plate. We got the peirce figured out as it is good only the corners are an issue now. Most corners are good but too often they get overcut when coming out of the corner. Could anyone tell me what paramter in the edge conditions make the most difference...- Mario428
- Thread
- Replies: 14
- Forum: Laser engineering
