I have an aluminum heat sink that uses water to keep the temperature near constant at ambient. I am removing about 5-10 watts from the sink. I am using a small circulating pump and a 50 gallon reservoir as a radiator. The heat sink is connected to the reservoir through a pair of 3/16" ID lines...
I recently acquired a Staubli RS80 and a IQ200 controller. I was told that they were a matched set but the connectors do not match. Is there a junction box for this system?
Does anyone have a CS8C for sale?
Thank you.
The prototype motor windings and pole pieces are 2" diameter. The pole pieces are wedge shaped with the inside making a circle about 0.6 mm. The 2" size of the pole pieces allow for easy hand winding.
I am fabricating a multipole induction motor with a very small rotor. I will machine ferrite wedges and secure them together to make motor poles. I need large ferrite disks 2.5" diameter by 1 inch thick to make the wedges. I want a high mu powder that will allow about 100000 Hz switching. Where...
