Is there a problem with running UG and Solidworks on the same machine simutaneously. My workstation is the server for UG Licenses and the floating license on SW also. If I reboot and run either program there is not a problem, if I run one program, close it, and then run the other, my machine...
I've never tried this personally (i.e. don't blame me if it doesn't work). I've heard of people injecting uncooked rice down the intake while the engine is running. Of course these engines don't have catalytic converters.
Allen
I am trying to develop a four cylinder stationary engine that normally uses balance shafts. The shafts have been removed for cost savings and the engine will be ran at a lower speed and derated horsepower to compete in a different market. My problem being that when I run the engine on the dyno...
Thanks for all of the replies. I'm actually trying to determine the tensile and hardness to specify for rod bolts that are used in a specific application.
Allen
I am looking for a way to measure volume of gas consumed by a diaphragm operated pump over a length of time. The pressure ranges from 5-85 psi and the volume can be from almost zero to roughly 22 cfm. What is a good way to measure this, as flow is not consistent I think I will probably need some...
I am having problems with distributor caps cracking on stationary engines. We began to use CD systems with a pickup years ago, however we would like to revisit using a distributor again if there is any way to keep the caps from cracking. The body of the distributor is vented on the side and on...
Does anybody have any experience using small air-cooled engines (i.e. b&s or kohler) in the 11-20 HP range for pump jacks. I have heard that very frequent oil changes are a concern as well as short life-spans.
thank-you
Allen Richardson
