My company just upgraded to 2k7 SP4 and now I am unable to use the surfacing trim or extend feature. When I try to do it it says it cannot do it because their is rebuild errors.
Completely stuck, 50% of my job is using surfaces and if I can't do this I am in deep water.
Any thoughts? Has...
this doesnt seem clear to me as to why it would allow it to thicken at 3mm but not 1.25. if there was interference it would be at both sizes would it not?
I have no fillets in my parts at all. ALTHOUGH, i do have several surfaces that are 3d. (slight wave appearance) instead of just a flat 2d surface.
I cant figure out how to post a pic so i cant show u graphically.
It will not work with an offset either (i used an offset of 0 from a different part to create these surfaces to start with but, when I try to offset surfaces 1.25mm it says cannot do it, try a smaller offset. How does this help me see where i have a problem? the preview doesn't really show me...
I have a complicated part with 34 faces on 34 different planes. when i try to thicken it i get the error.... "UNABLE TO THICKEN THE SURFACE" when i try to thicking it the thickness i want. 1.25mm. BUT when i thicken it to 3mm or more it works fine. What could possibly be preventing this from...
