Search results for query: *

Thanks "polleke" for your respond

hi i'm loocking for europen training about 5 days maximum concerning cathodic protection : France, Belgium..... help advices....

Hi after 3 years of use we need to change our probes (ER,LPR ). my question is shall we bey all the probe or just the insulator and some o-rings ? did you extracted probes on pipeline service or at shut down period? thanks to all helps

Hi did you performed in your plant an intelligent pipeline pigging? how much dose it cost? was it helpful ?

maybe the capacitf current (Ic) due to the earth fault is bigger than the protection rating current(Ir). the normal setting Ir>3xIc.

the classical case of a feeder MV cable for an impedance Z at L distance. actually i want to make a program that calculate and i hope enrich it step by step. thaks

It's incredible, i can't find any goo document to perform a MV cable section, so if an angel read this ...HELP. Thanks

In the case of unbalanced system the neutral is not neutral ..!

An induction motor has form 5 to 7 time power at starting than in nominal running. you have a motor: P=110kW -> S=138 KVA at nominal running. when starting : S=(5to7)x 138 = 690 to 966 KVA needed !it but yoy have just a generator about 480 KW-> 600 KVA. i thing you need to change the starting...

HI You can test the two software, by using a known exempel, try a simple circuit with one source and one self (if you want R+jX) but constant R and X. compare with your calculation note ! still use P.U .

There is a method not widely used : conecting capacitors during starting motor, this method is delicate because of overvoltage risk.

I have to feed Base Camp, power needed 4 MW, 5,5 KV (50Hz, the cable length is 6000 m. how (formula or the norme) must i choose the cable ?? what is the right steps ??? thanks.