Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
ANSI spline call out
Hi, i was reading the following thread, http://www.eng-tips.com/viewthread.cfm?qid=93789 and it seemed to be along the same lines as what i was looking for, but unfortunately it is closed. I am trying to figure out the correct way to call out a spline in a drawing. my current method looks...- roysh
- Thread
- Replies: 3
- Forum: Mechanical engineering general discussion
