Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Roll Center...Again
To start with - intersecting line kinematic roll centers have way too large an error rate. For example, I can have a 4 inch high by 6 inch to the right roll center using this method and have 2 differant cars with totaly differant a-arm angles not to mention lengths or anything to do with pin...- jb56
- Post #4
- Forum: Automotive suspension engineering
-
Force-based roll centres vs geometrical roll centres
I've been researching and testing this topic very heavily with NASCAR type stock cars. I've found that a combination of gRC and fRC helpful in both design and prediction of the race car. When I design new component sizes such as spindle heights, pin angles, pin heights, a-arm lengths, etc., I...- jb56
- Post #25
- Forum: Automotive suspension engineering
