Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. lectricman

    Multiple pv 550s with SLC 5/05

    I have a project to add another Allen Bradley PV 550 to an exsisting install.The current PV 550 is a RS 232 comms only unit as thats what the port on the SLC 5/05 is along with the ethernet port.Is there any way to add another pv 550 to this PLC ?
  2. lectricman

    INDUCTION HEATING PROBLEM

    This is only part of a autoloading system for a press . The base plate ,which also supports other members of the system ,was thought to be ok if made from carbon steel to keep the cost down as it is approximately 18 sq. ft .Being that it runs at 140 KW / 9 KHZ , it generates a substantial field...
  3. lectricman

    INDUCTION HEATING PROBLEM

    I recently installed an Induction Heater for heating carbon steel bars .The heating coil sits about 7" over the 3/4" steel plate that supports it . The problem is the 3/4" plate is heating up to well over 200 deg f after just a few minutes of operation .What can be put between the coil and the...
  4. lectricman

    Removing Load Bearing Wall and Replacing it With a Beam

    This wall supports the cieling joists which overlap 24" and the 1/2" gypsm board . The attic is not used for storage .
  5. lectricman

    Removing Load Bearing Wall and Replacing it With a Beam

    I want to open up some space in my 1 story ranch .I would like to remove the load bearing wall that runs down the center of the house. I would make a 30' beam from 4-2x10's on a 2x12 that would be in the attic space ,on top of ,and secured to all of the 2x6 ceiling joists from the attic side ...
  6. lectricman

    SENSOR THAT WILL DETECT DISTANCE

    The bars are in a rack next to each other. The purpose of the sensor is to locate the center of each bar so the robot can pick it out of the rack utilizing a magnet mounted on the same robot.The range it would need to detect would be approx. 6" ,down to 2" when it would lower down to pick up the...
  7. lectricman

    SENSOR THAT WILL DETECT DISTANCE

    NEED HELP LOCATING A DC SENSOR THAT IS TO BE MOUNTED ON A ROBOTIC ARM THAT WILL DETECT VARIATIONS IN HEIGHT FROM THE TARGET .TARGET SIZE IS APPROX.1.125 ROUND STEEL BARS
  8. lectricman

    A-B Resolver noise problems

    Having occassional noise problems on a forging press with 2 Allen-Bradley resolvers into 2 AMCI resolver cards which are in a SLC500 chassis.What belden cable will offer the highest noise immunity?

Part and Inventory Search

Back
Top