Zartan;
As long you know the nodes or keypoints that you want to edit you can make the changes thru the same macro. Other thing that you may consider is to create a element side of the deformed shape and make the changes in the file then run subsequent analysis...
Zartan;
If I understood correctly what you want to do is posible by using load steps (look for LS command in the Ansys help). What do you need is to create a macro that apply the load that will deform the shape, then clear loads and apply subsequents loads, finally read the final load step...
I agree with Madkungfu.
Many HVAC/R firm lack of a good SCADA personnel or only know certain programs which are not compatible with a particular plant standard.
Gary;
I think you should narrow the phrase "mechanical design". You can design a lot of things, from a pen to a space shuttle. Define the area where you will like to work. This will also help you to select your courses in your MSME.
You always can choose classes that give you what...
pumpdesigner,
I most guess that the damage was cause mainly by a misalignment on the pump shaft. At least that what I can guess from the picture. It looks like there is some wear in the shaft housing (upper section). Misalignment can cause cavitations and vibration stresses causing, as many...
