I have two parallel surfaces. One surface is Datum A, the other surface is specified to be parallel to Datum A within 0.001 inches. Is it true that both faces are also guaranteed to be flat within 0.001 inches or do I need to specify flatness separately? See attached picture.
Thanks,
Ryan
No, I'm pretty sure McAfee was running during the install. I don't remember explicitly turning it off. What problems might this have caused?
The uninstall was performed through "Add & Remove Prgrams". I just went through and removed each package (i.e. SW, Cosmos, Edrawings, etc.).
3.4 Ghz P4...
I just upgraded from SW 2007 SP2.1 to SP4.0 and my computer immediately started crashing. Using SolidWorks caused it to crash in a few seconds. Using other programs even caused it to crash in a few minutes.
Tech support recommended a complete unistall including all registry references. This...
Hello,
My name is Ryan and I am using MDT v4. I am trying to figure out how to place text on parts to help identify them in complex assemblies. I know in PROE you can create a sketch profile of text and then extrude/cut it a very small depth to create the illusion of an engraving. Is there...
