Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: Vai
  • Order by date
  1. Vai

    Polishing Alloy with a rough surface

    I have a single sided alloy swingarm on a Honda bike that I am going to polish, the surface is very rough as if its been cast. Will the first process of polishing be with a compound or by a grit based paper ? I have seen it done with a grade 240 paper then compounded afterwards, but I am...
  2. Vai

    Polishing Alloy with a rough surface

    I have a single sided alloy swingarm on a Honda bike that I am going to polish, the surface is very rough as if its been cast. Will the first process of polishing be with a compound or by a grit based paper ? I have seen it done with a grade 240 paper then compounded afterwards, but I am...
  3. Vai

    Advise on Butt Welding Mild Steel

    I am going to give it a go with my basic Arc Welder and the rods that have been suggested, so 45 amps and loads of old material to practice on ! Thanks guys, will let you know if I manage it .
  4. Vai

    Advise on Butt Welding Mild Steel

    I can go as low as 45 amps, but when getting the rods, I was told it would be a sod to do .....and that I should use a tig welder. I keep getting these conflicting comments !!!
  5. Vai

    Advise on Butt Welding Mild Steel

    First of all, let me apologise for an amateur entering your forums, but I am in need of some expert advice. I am in the process of fabricating a one off exhaust system, that was originally going to use Stainless Grade 304 1.5 inch OD, wall thickness 1.5 mm, but due to problems finding local...

Part and Inventory Search

Back
Top