Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. HH Choi

    Would nut rotate by torque wrench even if completed by hydraulic tensioning

    Thank you for all, Regards,
  2. HH Choi

    Would nut rotate by torque wrench even if completed by hydraulic tensioning

    Well,, fastener length would not be a factor to rotate nut, in this case. It was not so long.
  3. HH Choi

    Would nut rotate by torque wrench even if completed by hydraulic tensioning

    It was not planned to use torque wrench at tensioned joint, but a informality check using torque wrench. I agree to have consistent method for tightening. But not sure what made nut rotate even if hydraulic tensioned per vendor procedure. Maybe it was not correctly ready and/or tensioned, or...
  4. HH Choi

    Would nut rotate by torque wrench even if completed by hydraulic tensioning

    Hi there, I would like to ask advice about applying torquing where hydraulic tensioning has been completed. One of reports describes that some nuts on flange joint are rotating (I mean tighten) by torque wrench (hydraulic or manual) when apply torque value per ASME PCC-1, even if it has been...

Part and Inventory Search

Back
Top