Hello, sorry for the late reply.
Turning on eprint shows the following in the error message:
Begin Static Solution
Using the Calahan linear system solver.
Time T=0.000000000E+00.
Degree-of-freedom analysis identified redundant constraints in the model...
I ended up fixing the powertrain problem.
Now when I try to run an acceleration test I get an error regarding an "incompatible constraint". This wouldn't usually be a problem, but the software doesn't even specify which constraint is causing the error. All I get is:
Time :0.000000000E+00
The...
Thanks for the reply.
Increasing maxit did not fix the error, neither did moving the subsystem.
Other types of tests (straight line drive, maintain etc.) also yielded the same error.
Hello, I keep running into this error message when trying to set up an acceleration test of a full vehicle assembly.
---- START: ERROR ----
Static equilibrium analysis has not been successful.
The maximum number of iterations 25, has been reached.
For the last attempted iteration:
The...
Hello, our rear suspension template has been running into some problems.
Specifically, while the opposite travel tests run normally, the outer tierod forces shown on the post-processing window are close to zero. This happens on every axis.
I have also saved the message logs from the same...
