Pmarc,
Thank you for a very detailed response.
So when you were describing the upper-segment tolerance, you said it "not only controls spacing WITHIN the pattern...". Can you clarify what you mean here? I am assuming you mean like, the spacing of the pattern as a unit relative to the basic...
I agree with what you are saying 100%. See the drawing below. What you just described is exactly what I put on my initial drawing. However, I received mark ups and was told that "the only datums needed should be Datum B as the axes of the two 7mm holes, and the flat surface that those holes are...
Hello,
Thanks for the response. I think I should have just supplied the actual drawing to explain.
So this is what I had in mind, but the issue I'm having is whether or not the upper segment here is correct. The problem is that I really only have 2 datums on this drawing: the flat...
Hello all. First time post here. Soon-to-be graduated engineer currently in an internship.
So I am working on preparing drawings for some brackets I’ve designed, and I have a request to change something from management that I am not sure how to go about.
For a composite position tolerance (in...
