Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Is a dielectric union required on 316SS tubing used for chemical injection.?
thank you TugboatEng, EdStainless, SJones for your quick response, knowledge and advice. I needed some backup since some thought that the DU was to protect the buried tubing. I am going to check that the isolation kit is properly installed where the flowline goes into the ground. We'll use sand...- TXRVD
- Post #5
- Forum: Corrosion engineering
-
Is a dielectric union required on 316SS tubing used for chemical injection.?
I have an installation where a pneumatic chemical pump is approx. 100 FT from a wellhead. The chemical injection pump discharge 316SS tubing is buried around 4 FT deep, comes above ground and connects to a 316SS ball valve, check valve and injection quill that is on a carbon steel flowline. The...- TXRVD
- Thread
- Replies: 9
- Forum: Corrosion engineering
