Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Mullemeck

    Determining oil bath volume

    Hi all, How would you go about deciding the oil volume (not level) for an oil bath lubricated bearing housing? By plain intuition (maybe wrong here) I think that oil volume should dictate oil change intervals and how much heat the bearing housing is able to dissipate, am I totally off the...
  2. Mullemeck

    Sealing a sphere

    Dear all, Pressure will be around atm as this component will sit around slightly above or below the waterline. A cylinder will be attached to the sphere on the dry side and the rod will pass thru the sphere, the use of the sphere as a attachment point will reduce any side forces acting on the...
  3. Mullemeck

    Sealing a sphere

    I am working on a design where I need to seal a sphere. The sphere shall pivot in one plane with relatively small tilting angles. The wet side is a corrosive and dirty environment and it is highly critical that no seepage of occur between the wet side and dry side. My initial ideas are to seal...

Part and Inventory Search

Back
Top