Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Downcomer Welding
Where I work there is a water tube boiler, I noticed that the welds of the water wall tubes to the downcomer do not have full penetration. Wall tubes 2 " Downcomer 6 " I am not an expert on the subject, but when reading PW-9, it is understood that these welds need full penetration. Should I...- PHR_BR
- Thread
- Replies: 2
- Forum: ASME (mechanical) Code Issues
-
Brazed Plate Heat Exchanger Design
I am looking for an alternative to calculation and not proof tests. I already researched in: ASME VIII, Div. 1 U-2 (g) UG-101 CODE CASE 2766 Any suggestion?- PHR_BR
- Post #3
- Forum: ASME (mechanical) Code Issues
-
Brazed Plate Heat Exchanger Design
Good Afternoon. How to calculate the required thickness of heat transfer plates in Brazed Plate Heat Exchangers (BPHE) as per Section VIII Division 1? Other code? Is it a U-2 (g) case? I really need to know how to do this, either by ASME, EN or other code. Best Regards!- PHR_BR
- Thread
- Replies: 3
- Forum: ASME (mechanical) Code Issues
