Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. WarrenG701

    Bethspan Steel Joists

    Hello, I came across this thread https://www.eng-tips.com/viewthread.cfm?qid=74306#post because I am having a similar issue. I was wondering if the two fellow engineers did not mind sending me the PDF joist manuals that you may have, that deals with Bethlehem steel joists. Specifically, I am...
  2. WarrenG701

    Problem with Modeling Truss in Staad Pro.

    @BAretired I would normally calculate these kinds of forces by hand. The problem is the client for the project is looking for a solution and a quick turnaround to issue repair sketches to the failing truss. Calculating the forces by hand doing the joint method would just take too long and is...
  3. WarrenG701

    Problem with Modeling Truss in Staad Pro.

    @Dozer Thank you very much, this solved my issue. I was able to get the correct outputs after that.
  4. WarrenG701

    Problem with Modeling Truss in Staad Pro.

    Stevehh49 Firstly thank you for taking the time to review my model. I am going to review my chord properties more closely. Also I will read the warnings and notes again. As far as the supports do you have a suggestion as how the supports should be modeled ? I know usually a truss is pin and...
  5. WarrenG701

    Problem with Modeling Truss in Staad Pro.

    Hello, I am having an issue with a truss staad model. It is a simple 2d model of a single span monopitch timber truss supported at either end by bearing walls. The span is 38'-8" and depth is 12'-0". Top and bottom chords are (2) 2x6's, and vertical and diagonal web members are 2x4's. The...
  6. WarrenG701

    Modeling Supports for a "U" Shaped Concrete Frame

    Hello HotRod10 First and foremost thank you very much for reply. I understand what you are explaining in terms of the assumptions for the supports when it comes to the design of each individual component. However, I am still unclear in terms of modeling the supports as an entire system...
  7. WarrenG701

    Modeling Supports for a "U" Shaped Concrete Frame

    I am currently working on a simple frame that consists of 2 reinforced concrete square columns and a reinforced concrete grade beam at the base of the columns that spans between the support of the columns. The columns are each supported by pile caps and pile foundations at the base and as...

Part and Inventory Search

Back
Top