Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. mgilbertson

    PLF Load based on 16" spacing

    I am trying to design a beam based on 810# end reaction of the supported products. The products are spaced 16" apart. I know to take that end reaction divide by 2 to get a plf load on that beam for 24" spacing. But do not recall how to get for 16" spacing.
  2. mgilbertson

    Roof Ledger Board Attached to Wood Wall

    I am currently designing roof trusses for a house. The garage is actually about 44" below the house height. The garage has a 3rd car stall. These trusses run perpendicular to the house. Essentially, they will need to be hung on something to get the girder in the right position to support the...
  3. mgilbertson

    Excel - 'X' in cell upon clicking

    Thank you very much!!! Works perfectly!!
  4. mgilbertson

    Excel - 'X' in cell upon clicking

    Thank you for your help. This worked great. I just have one change. There are actually two sections that need this. The original as shown, and also E/F74 - E/F106. Is it possible to do two sections? Thank you.
  5. mgilbertson

    Excel - 'X' in cell upon clicking

    I am looking for a way to enter an 'X' in a cell when double clicked. The cell next to it should then be clear. See example below. If I click on cell 'E20', then I want an 'X' to appear, and cell 'F20' is blank, and vice versa. Thank you.

Part and Inventory Search

Back
Top