Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. karicow

    Steel OMF in SDC D

    ASCE 7-10 table 12.2-1 says steel ordinary moment frames are not permitted in seismic design category 'D' and higher, with the footnote 'i' leading you to section 12.2.5.6. That section does allow the use of OMF in SDC 'D' for a single story building up to a height of 65 ft "where the dead load...
  2. karicow

    Anybody licensed as PE in Misssissippi that took SE1 prior to 2011?

    "Guess I should just get licensed in as many states as possible and keep them current to future-proof my licenses." I wish this was an affordable plan, or I'd do the same! Some good news from Georgia. That was likely the next on on my list, so I sent their executive director a message...
  3. karicow

    Anybody licensed as PE in Misssissippi that took SE1 prior to 2011?

    I'm a practicing structural engineer and my home state is NC. I've applied for and had no issues with obtaining P.E. licenses by comity in several other states (AL, VA, LA), but have hit a snag with Mississippi. They are denying my application for licensure because they say I have not "fully...

Part and Inventory Search

Back
Top