Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Markeng512

    4 points seat belts forces

    Hi all, in the project I am working on, I have analyze a sort of crew rest area. In one configuration of this monument, the crew will be sit and secured with 4 points seat belts. My question is: Is there the possibility to get the loads on the attachment points in all 6 loadcases...
  2. Markeng512

    Responsibilities of a CVE and of a preparer of a stress report

    Thank you rb1957 for your fast answer. Yes you are right, it doesn´t matter to have multiple signs since the report is checked and approved. It is a bit complicated because the data prepared by the other are not visible in the report, but I use them to make other calculation. But here comes...
  3. Markeng512

    Responsibilities of a CVE and of a preparer of a stress report

    Hi all, I have a question that concern the legal aspect of our work. I am an Aerospace Engineer with 3 years of experience in stress. I work for a consultancy company and at the moment I am preparing a very complicated stress report for a costumer company. Since there is a lot of work, it has...
  4. Markeng512

    SPCD analisys with displacement from another model

    Hi leo16, thanks for your answer. why do you think that is not good to use displacements for the analysis of a single part?
  5. Markeng512

    FEMAP contact

    Hi all, I run a model in which there is a glue contact. In the f06 I have these warning but I don't now how to interpret them: *** USER WARNING MESSAGE 4690 (CNTGAPERR) The gap between glue faces of some elements in gap pair 73 between regions 3049 and 3063...
  6. Markeng512

    FEMAP buckling problem

    Hi, I hope that someone of you can help me. I realized a model of a partition in sandwich material that is connected to the floor through 2 shock absorber and on the upper part with two pins. The shock absorbers have been modeled with damper/cbush with coincident nodes that connect throug...
  7. Markeng512

    Stress concentration in solid modeled with TET10

    Thanks Mustaine3, but in reality I am using Femap that I think doesn't have this functionality.
  8. Markeng512

    Stress concentration in solid modeled with TET10

    Hi everybody, I received a very big complex to model. For one of the attachmetn I removed a very big fillet leaving an 90 deg angle. In the simulation I have a peak of stress in that area. Would it be possible to show through an analytical calculation the stress value in that area if there was...
  9. Markeng512

    SPCD analisys with displacement from another model

    Hi guys, I am new in this forum and I have to say that from the discussions I learnd a lot. I am Marco from Italy. I made a very big model in Femap with a lot of component modelled with shell. After an analysis a saw that this component is critical. Now I realized another model with the item...

Part and Inventory Search

Back
Top