Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. PGP_1967

    Hydraulics System Issue

    Hello Team / Hydraulic experts We are in a situation as described below. we have a turret punching machine. the machine is equipped with hydraulic system for rapid punching. the system has a Yuken A37770 Double piston pump. Pump One is supposed to deliver 9 MPA and Pump Two is supposed to...
  2. PGP_1967

    NC GAS Controller ( AMADA FO 3015 )

    Hi Laserninja, Thanks for your response. i think the connection between NC Gas controller card and NC Mother board is exactly same for DOM / EXP / EU models. The actual NC gas controller differs in EU model. I don't think there should be any problem...to retrofit the Std. NC Gas Regulator /...
  3. PGP_1967

    NC GAS Controller ( AMADA FO 3015 )

    Attachmentshttp://files.engineering.com/getfile.aspx?folder=309988d6-da00-41f5-9540-0caa5c291011&file=Assist_Gas_Diagram.pdf, http://files.engineering.com/getfile.aspx?folder=b10e9224-8217-4f1f-a7b0-3bc012f8e70b&file=Assist_Gas_01.pdf
  4. PGP_1967

    NC GAS Controller ( AMADA FO 3015 )

    Hi Members, Here is a Situation, We have one AMADA FO 3015 machine .....its a 2nd hand machine purchased from dealer in UK ....around six months back. we were not able to commission the machine due to several reasons. Most of them are now resolved....except one The NC Gas controller system...
  5. PGP_1967

    thread380-361460 Hi LaserNinja,

    Thanks RPosty, Shall try to adjust the Base Discharge ....as explained in the Fanuc manual. thanks.
  6. PGP_1967

    thread380-361460 Hi LaserNinja,

    Thanks LaserNinja, I am in a situation on Muratec Centrum C3000 ( Fanuc C2000 B ) Hybrid machine. The Laser resonator was kept Idle for last 8 months or so.....just because client did not know how to operate. when I checked ....and started the resonator ....came up to 1200 W ...throwing the "...
  7. PGP_1967

    thread380-361460 Hi LaserNinja,

    thread380-361460 Hi LaserNinja, You mentioned FLUKE meter to measure the Laser power at FANUC Intermediate board. Can you please provide the Model no of FLUKE meter to be used....? thanks.

Part and Inventory Search

Back
Top