Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Looking for an inspection method for this true position callout
According to my customer contact the position of the slot pattern is described by the theoretical bolt circle of center points of those 36 slots. The geometry of each individual slot however is not on center of a point placed .758" from the center point of Datum -B-. You will notice the...- Iceman13
- Post #7
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Looking for an inspection method for this true position callout
Good morning, I am looking for an acceptable method of checking the true position callout on a part we are manufacturing WITHOUT the use of a CMM. My idea is to use a pin micrometer to check the locations of the slots in this part at 6 places around the OD. I am wondering if this inspection...- Iceman13
- Thread
- Replies: 9
- Forum: Drafting Standards, GD&T & Tolerance Analysis
