Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. AlexCLE

    Post builder change full circles to shorter arcs

    Hi. I'm using a CNC controller (Estlcam) that does not support complete circles in one line of G-code. For example, when I import this code: N7 G01 X9.6 Y46.3 N8 G02 X10. Y46.699 I.4 J0.0 N9 G02 X10. Y46.699 Z-4.162 I0.0 J-1.41 K-1.14 The G02 arcs (complete circles) are ignored and replaced...
  2. AlexCLE

    NX Post processor unit mismatch problem

    I'm using the generic 3 axis mill post in NX9 for a part. When I run post and leave the unit setting as "Post Defined", I get metric but I need inch in my program. Though when I open this post in Post Builder it has inch set for "post output unit" in the Machine Tool tab. If, in NX, I change the...
  3. AlexCLE

    Manufacturing module questions

    I'm starting to work with Manufacturing for the first time and have a few questions: Is there a way to show total machining time for a part? If I go into "information" for each operation there is a time listed there but for a large part it's time consuming to go through each operation. Is this...
  4. AlexCLE

    Manufacturing template units don't match model error

    I think I got it sorted out. I had another part open that was metric, and had it in Manufacturing with a metric template. It seems that trying to load the inch template on another part caused the conflict. I closed the other part and got the inch template to work.
  5. AlexCLE

    Manufacturing template units don't match model error

    I'm using NX9 and have a model with units in inches and when I do File/New/Manufacturing tab/Machinery (Express) template with inches as units, I get an error that the template units don't match the part template. If I select General Setup instead of Machinery (Express) then it works fine. Is...
  6. AlexCLE

    rehardening 4140HT after flame bending

    I need to make some hook-shaped parts from 3/4" OD 4140HT round bar and I'm using an oxy-acetelene torch to heat the rods for bending. Would letting these air cool afterwards just anneal them? Can I re-heat treat and temper them to bring back some strength; what would be the procedure? I don't...

Part and Inventory Search

Back
Top