Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Request from a Colleague - Can he view Sketch Dimensions to the third or fourth decimal place in NX?
The only way I can get this to work is by right clicking on each dimension. I cant find the preferences->annotation menu and I've attached a screenshot so if someone could point me in the right direction that would be great. I have every setting I can find set to more than one decimal place in...- Trevz87
- Post #5
- Forum: Siemens: UG/NX
-
Operation Start for Tapping in NX Post
Thanks Greg, I'm sure that's close - but I'm still learning post builder and still very green with Tcl. I have the command above the G84 output(in the same block) but I still get the error in the attached screenshot. I've tried to figure it out but I'm not having much success. Could you...- Trevz87
- Post #3
- Forum: Siemens: UG/NX
-
Operation Start for Tapping in NX Post
thread561-177672 Hi, I have the same issue as in the referenced thread and it seems the original question was never fully answered. In our case I would like to have a different operation start and op end for tapping(if possible)- I like to use G95 so the the operator is looking at the thread...- Trevz87
- Thread
- Replies: 4
- Forum: Siemens: UG/NX
