Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. koushik123

    Suspension Analysis using Matlab

    Hello everyone I have just started a new project on my own.Though there are numerous softwares to carry out suspension geometry analysis I always had an interest to do the same using matlab. Project Goal : To carry out suspension geometry analysis using MATLAB for an open wheeler car.The...
  2. koushik123

    Design of a column for machine

    Thank you for your valuable replies gentlemen
  3. koushik123

    Design of a column for machine

    Hello everyone I am designing a machine which has got two cylindrical hollow aluminum columns on its either side to hold the machine.For better understanding , I have attached a picture of it below. My question is A side load of around 1500 N acts on the column radially at half of its...
  4. koushik123

    Suggest a suitable Motor

    The weight of the shock absorber that will be tested in this machine ranges upto 13 KG
  5. koushik123

    Suggest a suitable Motor

    I'm in the process of building a shock absorber dynamometer.I have planned to use a 2 HP motor with a max RPM of 1750 for this. But the required working range is from 20 RPM-200 RPM 1.Is it possible to achieve this using a VFD?? 2.And kindly guide me whether to choose an AC or DC drive?? and...
  6. koushik123

    DIY Shock Dyno

    Thanks a lot TC3000...Very informative..
  7. koushik123

    DIY Shock Dyno

    Hi TC3000 Thanks a lot for your useful reply.. By the way can you explain what different bearings should we have to use in this machine and how to select it?? We need bearings for 1.Conrod ( crank side) 2.Conrod ( slider side) 3.Slider How to select these?? Well thats all i guess!! will i...
  8. koushik123

    DIY Shock Dyno

    Hi everyone I am in the process of building my own shock dynamometer for racing applications. An overview of my design 1.Motor : 3 Hp,Single phase,220 v motor with a Max rpm of 3450 2.Mechanism : Slider crank mechanism with a setup to provide different stroke lengths ranging from...
  9. koushik123

    Static Equilbirium analysis error

    I was trying to run a suspension analysis and in turn I get the following error in Adams/Car Static equilibrium analysis has not been successful. The maximum number of iterations 25, has been reached. For the last attempted iteration: The equation with the largest error was contact Comp = 5...
  10. koushik123

    Tips & Tricks for ADAMS/CAR template builder

    Thank you for you reply Greg.. I was trying to run a suspension analysis and in turn i get these errors.. Static equilibrium analysis has not been successful. The maximum number of iterations 25, has been reached. For the last attempted iteration: The equation with the largest error was contact...
  11. koushik123

    Tips & Tricks for ADAMS/CAR template builder

    Can someone please state the important points to be remembered while building a suspension template in ADAMS/CAR?? Some tricks and tips for ADAMS/CAR template builder are also welcome :)

Part and Inventory Search

Back
Top