Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. shughes123

    Pipe wall thickness -ASME B31.3

    As per 31.3, in wall thickness calculation formula, for the coeficient Y, a table is given for t < D/6. And for " For t ≥ D/6 or for P/SE > 0.385, calculation of pressure design thickness for straight pipe requires special consideration of factors such as theory of failure, effects of fatigue...
  2. shughes123

    Relation between hardness and Corrosion

    What is relation between hardness and subsequently the corrosion of material.....Also need point of views w.r.t NACE for this
  3. shughes123

    Sch 10 Stainless Steel Weldolet

    Thanks guys...I had heard a specific name about this type of weldolet particularly of SS material....
  4. shughes123

    Sch 10 Stainless Steel Weldolet

    whats this Sch 10 weldolet of SS called
  5. shughes123

    Sch 10 Stainless Steel Weldolet

    hello.. Is it recommended to use Sch 10 Stainless Steel Weldolet? and is there any specific term for these types of weldolets which are thin walled?
  6. shughes123

    Shell TAT/TAMAP list.

    is TAT applicable for check valves?? in PDO OMAN Type acceptance test for the Items is mandatory as per MESC SPE 77/300A. However this requirement shall be waived provided the Vendor complies with the following requirements. a. Third party Inspection (vendor scope) for the valve...
  7. shughes123

    valve material

    http://www.eng-tips.com/viewthread.cfm?qid=139571
  8. shughes123

    DEP / Shell Piping Classes

    What exactly you want to know in this piping class? below is basic info. Carbon steel Class no. 11011 ASME rating CLASS 150 Corrosion allowance 1 mm try below,, though it is very old revision Linkhttp://www.scribd.com/doc/39628674/rc-150
  9. shughes123

    36&quot; orifice flange

    I Need to Purchase a 36" orifice flange,but ASME b16.36 is upto24" only, can MSS SP 44 be referred to? Any useful tips how to proceed with this, and what standard should be considered.
  10. shughes123

    What is Type acceptance test (TAT)

    What is Type acceptance test (TAT) and when can it be waived off

Part and Inventory Search

Back
Top